[tscode field=”tabs” item=”KRG FAQs”]
-Do you have a LE or Mil discount?
We do have discounts for Active Duty Military members, Veterans, and POST certified LEO’s with PD’s/SO’s/Agencies. For Military personnel DO NOT send a picture of your ID (it will be deleted immediately). For active duty please send us an email from a .mil email account or a copy of orders. Veterans can send a copy of their DD-214. For LEOs a copy of your ID will work just fine. These can be sent to email@example.com
We will then send over the discount codes and you can order online.
-Will a Magpul 762 AC fit a Tikka T3?
The feed lips of the Magpul 762 AC mag are too thick to seat into the T3 (it’s designed for a Rem 700 SA). This is why we recommend steel mags (AI or Accurate Mag) for use with the T3. There have been forum posts by guys detailing how to file down an area of the Magpul’s feed lips to get the mag to seat fully. We have not done it, but it is reported to work well.
-Will you be coming out with a Howa Bravo for the mini or long action version?
We currently have no plans for a long action or mini action Howa chassis.
-Will you be coming out with a Bravo for Savage rifles?
No. Bringing this to the market would take an entire redesign of the Bravo chassis, which means brand new molds, extrusion dies, tooling, etc. Combine this with a much lower volume for Savage and the price point would end up being in the 180-Alpha range or more.
-Does KRG make a Tikka T3 chassis that fits a magnum or long action calibers?
Unfortunately, our chassis will not fit the Tikka T3s in any of the long action calibers. There are compatibility issues between the receiver and long action AICS magazines.
-Will the Bolt Lift fit other rifles?
The Bolt Lift is made specifically for the Remington 700 so it won’t fit perfectly on anything else. We have had customers install Bolt Lifts on Savage, Howa, and Mossberg rifles with some modification; however, KRG does not guarantee that it will work properly if modified.
-Can I run a WSM in a Tikka T3 chassis?
In theory you should have no problem running a WSM in a T3 in our chassis. Both Alpha Industries and Accurate Mag make a WSM mag in the .308 AICS mag footprint.
-Does KRG make a chassis for a left-handed Tikka T3?
We do not make a dedicated lefty Tikka T3 chassis, but we have designed our Whiskey-3 and X-Ray T3 chassis so that a decent gunsmith can make the modification easily. It would require cutting an inlet in the aluminum backbone and polymer grip panel for the bolt handle to lie in.
-What are the differences between the X-Ray Gen 1 and Gen 2?
The changes from the X-Ray Gen 1 to Gen 2 Chassis are as follows:
|Gen 1||Gen 2|
|V-block bedding||Radius bedding (in Remington 700 SA chassis only) to better accommodate the factory Remington tang|
|Aluminum trigger guard||Polymer trigger guard (in Remington 700 SA chassis only)|
|One-piece low-profile mag release||Straight lever, tapped for accessory mag release buttons|
|1 position cheekpiece||6 position cheekpiece for more range of fore/aft adjustment|
-Will KRG chassis fit the Tikka T3 CTR?
Our Whiskey-3 and X-Ray chassis will fit the Tikka T3 CTR! Keep in mind that it will then use AICS-type mags rather than the factory CTR mag. We recommend the steel mags from AI (3901 or 3902) or Accurate Mag (00100-0007 or 00100-0009) with that setup.